Exp-computer PathBuilder S200 Uživatelský manuál Strana 110

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 162
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 109
106 Bridging
LLC2 Local Termination
Configuring Local Termination
Configuring for
Local Termination
Perform the following procedures to configure Local Termination on a Bridge node.
Before You Begin Connect to the node using Control Terminal Port (CTP) access.
Obtain the following information:
MAC Address of the device being spoofed.
SAP value of the device being spoofed.
Configuring the
Bridge
Follow these steps to configure bridge parameters to enable Local Termination on a
node.
Step Action
1 Configure the node.
2 Configure the ports.
3 Configure the route selection table.
4 Configure the LAN connection table.
5 Configure the Mnemonic Table and PVC Setup table.
6 Configure the bridge for Local Termination.
Go to ““Configuring the Bridge” section on page 106”, for details on
configuring the bridge table for Local Termination.
Step Action Result
1 Select Configure -> Configure
Bridge from the Main menu.
Note
Bridge must be configured for
source routing.
(*Bridge Type=SR).
The Configure Bridge Record
menu appears.
Zobrazit stránku 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 161 162

Komentáře k této Příručce

Žádné komentáře